Whoops!

Everyone makes mistakes.  This time it was the person bending a batch of our crank sensor brackets at the factory.   Compare and contrast the two images below.






Rather than bending them "up" the brackets were bent "down" which means that they don't fit the A-series engine installations that we intended. We don't want these brackets going to waste so we're offering them on the Bargain Basement section of our website.

Coil-X RPM adaptor

Lots of modern equipment, be that data logger, rev counter, shiftlight or whatever needs an RPM feed but can only accept a 5-volt pulse.  If you've got an older engine that uses a traditional coil ignition then you're a bit stuck.  Now though we have the Coil-X adaptor which takes the high voltage "flyback" pulse from the ignition coil that drives older rev counters and converts it into a clean 5-volt pulse that modern equipment can understand.

You can find the Coil-X on our website